5 Installation Procedure
2.
Put the LED label (B) in the correct position on the drive front cover (A).
A - Drive front cover
3.
Install the option (A) into the CN5-A connector (C) on the drive and use one of the included screws (B) to
put it in place.
A - Option
B - Included screw
4.
Use one of the remaining included screws (B) to connect one end of the ground wire (C) to the ground
terminal (A). Use the last remaining included screw (B) to connect the other end of the ground wire (C) to
the remaining ground terminal and installation hole on the option (A).
Tighten the screws to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
14
Figure 5.3 Put the LED Label on the Drive Front Cover
Figure 5.4 Install the Option
B - LED label
C - Connector CN5-A
YASKAWA SIEP C730600 89E PROFINET Technical Manual