Error Messages - MIMAKI JV300-130 A Operation Manual

Error messages

When an error message is displayed, eliminate the error according to the chart below.
If it is displaying again, contact your dealer or an office of MIMAKI to call for service.
Message
ERROR 122
CHECK:SDRAM
ERROR 128
HDC FIFO OVER
ERROR 128
HDC FIFO UNDER
ERROR 129
BATTERY EXCHANGE
ERROR 130
HD DATA SEQ
ERROR 146
E-LOG SEQ
ERROR 151
Main PCB V1R2
ERROR 152
Main PCB V2R5
ERROR 153
Main PCB V3R3
ERROR 154
Main PCB V05
ERROR 157
Main PCB VTT
ERROR 16e
Main PCB V3R3B
ERROR 15f
HEAD DRIVE HOT
ERROR 171
NEW HEAD CONNECT
ERROR 186
HDC OVERFLOW
ERROR 186
HDC UNDERFLOW
ERROR 187
HDC SLEW RATE
ERROR 188
HDC MEMORY
ERROR 18a
Main PCB V_CORE
Cause
SDRAM is defective.
Head control circuit board is defective.
The battery life end of the internal clock
is detected.
Head data transferring sequence error
occurred.
Sequential number abnormality of the
event log occurred.
Error occurs in the power supply system
of the main board.
An error is detected on the waveform
printed on.
An error occurred in the main PCB .
Chapter5 Troubleshooting
Solution
• Turn off the power to the machine and turn it
on after a while.
• If it is displaying again, contact your local
distributor, our sales office or our call center.
• Contact your local distributor, our sales
office or our call center.
• Turn off the power to the machine and turn it
on after a while.
• If it is displaying again, contact your local
distributor, our sales office or our call center.
1
2
2
2
5
6
5-7