Sega After Burner Climax Owner's Manual page 53

Have available a DVD kit, which is sold separately. (See Table 5c.)
1
Before engaging the power supply, be sure that no one is on the base and that there are no tools, etc., on the
seat. When the product is shipped from the factory, the software has not yet been installed. But when the
software is installed and the power supply is engaged, the seat will move left and right.
2
Turn the main switch of the AC unit to ON and engage the power supply.
3
The LINDBERGH start-up screen appears. Wait for at least one minute. The error state is established.
Check to be sure it is "Error 22." If it is "Error 22," proceed to the next operation. If it is not "Error 22,"
refer to the LINDBERGH service manual and take corrective action.
4
Take out 1 urea (plastic head) screw and remove the DVD DRIVE case lid.
FIG. 6-8a
5
Press the DVD DRIVE switch and the DVD DRIVE tray will come out. Set the DVD from the DVD kit
into the tray. Always have the labeled side facing upward.
FIG. 6-8b
6
47