Sega After Burner Climax Owner's Manual page 54

6
Press the DVD DRIVE switch. The tray goes back into the drive.
7
Make sure no one is near the product, and then re-engage the power. Turn the main switch to OFF once,
wait for at least one minute, then turn the switch back to ON.
8
Software is installed automatically from the DVD to the LINDBERGH. In some cases, it may take about 5
minutes to install software to the LINDBERGH.
6
9
Upon completion of installation, initialization takes place automatically. The seat moves. Wait for the seat to
stop at a level position. Otherwise there could be accidents, errors or problems.
10
Initialization is completed when the Attract Mode screen appears.
11
Press the DVD DRIVE switch so that the tray comes out. Remove the DVD.
12
Press the DVD DRIVE switch so that the tray goes back into the unit. If the power is cut off, the tray will
not move.
13
Set the main switch to OFF.
14
Remove the DVD wire from the DVD DRIVE.
15
Attach the DVD DRIVE case lid and fasten it with 1 urea screw.
16
Unlock and remove rear door R.
17
Remove the DVD wire from the LINDBERGH and withdraw it from the bottom surface of the base. Leave
the key chip inserted.
18
Attach the cable lid to the base bottom plate. Fasten with 2 fl ange nuts.
19
Attach and lock Maintenance Cover L. And then fasten screws.
20
Store the DVD DRIVE, DVD wire and DVD kit in a location free of dust and cigarette smoke.
48