3
Remove 6 M5 X 35 round head wrench screws that holds the Maintenance cover L in place and turn the key.
Round Head Wrench Screw(6)
M5 X 35, Flat Washer Used
4
Remove the Maintenance cover L as shown below and pull out the sensor
connector inside through the rectangle opening on the side of the base.
Maintenance Cover L
5
Keep the maintenance cover L closed for safety(to keep objects falling into the
machine.) Do not fasten the screws at this time(for software installation.)
Key Lock
FIG. 6-2c
Sensor Connector(6P)
FIG. 6-2d
Maintenance Cover L
6
25