Sega After Burner Climax Owner's Manual page 52

8 SOFTWARE INSTALLATION
• When the software is installed, the seat moves left and right automatically. First
make sure no one is near the product, then engage the power. If someone is
near the product, they could come in contact with it or collide with it, get their
6
hand or fi nger caught somewhere, or accidentally fall down.
• Be careful not to damage the DVD wire by getting it caught between objects,
etc. Doing so may cause a short circuit or fi re.
• The following explanation assumes that the product has been assembled
properly as explained above. If there is an error or if the product operates in a
manner other than as indicated below, cut off the power supply immediately.
Failure to do so may result in a fi re or electrical shock.
• If you look directly at the laser beam in the DVD DRIVE, you could suffer vision
impairment. Do not look inside the DVD DRIVE.
• The software is not installed on the game board (LINDBERGH) when the power
supply is engaged, so the "Error 22" message is not a malfunction. However,
if there is another error display, or if there is no video output at all, there might
have been an error in product assembly, wiring connections might be faulty, or
the LINDBERGH might not be functioning properly.
• After the power supply is engaged, wait for "Error 22" message to be displayed.
If the product is indiscriminately operated in any way beforehand, there could
be unexpected problems or malfunctions, as well as damage to parts.
• Once "Error 22" is displayed, set the DVD-ROM in the DVD DRIVE and re-engage
the power supply. Installation takes place.
• After the power supply is engaged, the DVD DRIVE tray will not come out
for about 30 seconds even if you press the switch. This is due to DVD DRIVE
initialization.
• The DVD DRIVE tray can come out or return only while the power supply is
engaged. The tray cannot be opened or closed while the power is off.
• Even after the software has been installed, store the DVD software kit, DVD DRIVE
and DVD wire in a secure location.
• If for any reason installation cannot be completed, an error is displayed. Refer
to the service manual and take corrective action.
46