Table of Contents
Advertisement
Chapter 3:
Machine Calibration
A profile wizard starts automatically and must be completed the first time which the steering
module is accessed after installation or any time the ECU is reset.
Refer to "Reset Calibrated Gains" on page 93 for additional information about resetting the
steering system.
Note:
System Information, Diagnostic Trouble Codes (DTCs), and Machine Test screens may
be viewed during the initial calibration process. Refer to the following topics for additional
assistance with the settings available during the initial calibration wizard.
"SGC System Information" on page 194
l
"Diagnostic Trouble Codes (DTCs)" on page 145
l
NOTICE
Installation of the system must be fully completed before
calibrating the system. Refer to the machine-specific installation
manual or contact your local Raven dealer for assistance with
installing the system.
Machine Calibration
15
Advertisement
Table of Contents
