Calibrate The Smartrax System; System Disengage Calibration; Smartrax Systems With A Pressure Or Flow Switch Installed - Raven SmarTrax Calibration & Operation Manual

C 3
HAPTER
FIGURE 10. Steering Control Device Selection Screen
NOTE: The steering control device selection screen will display a (-) until a steering control device is selected
from the drop-down box.
3. Select the device being used to control the SmarTrax system.
• Raven Hydraulic - SmarTrax hydraulic valve is controlling the vehicle steering.
• Steer-Ready - SmarTrax is connected to an optional steering control system that was installed at the
factory.
4. Select Next.

CALIBRATE THE SMARTRAX SYSTEM

NOTE: The calibration wizard will be displayed the first time the SmarTrax module is accessed after
installation or any time the Reset SmarTrax option is selected. Refer to Reset Calibration section on
page 37 for additional information about resetting the SmarTrax system.
1. Park the machine on a level surface.
2. Locate and select the SmarTrax module. The calibration wizard will start automatically if the SmarTrax system
requires calibration.

SYSTEM DISENGAGE CALIBRATION

SMARTRAX SYSTEMS WITH A PRESSURE OR FLOW SWITCH INSTALLED

IMPORTANT: This section applies only to SmarTrax systems utilizing a pressure or flow switch to disengage the SmarTrax
system when the steering wheel is turned. If a pressure transducer is installed in the SmarTrax system, refer
to the SmarTrax Systems with a Pressure Transducer Installed section on page 17 to calibrate the SmarTrax
system.
1. Select Next in the SmarTrax Setup Wizard. The following screen will appear:
16 ROS SmarTrax™ Calibration & Operation Manual