Fig. 4.20 Connection Of The External Ecr Drawer; Fig. 4.21 Modular Jack 4×4 Connexion - ELCOM Euro-500 Handy Series Service Manual

Euro-500TX Handy
Note 1: External drawers with solenoid current greater than 1 A are not recommended.
Note 2: In order to prevent any trouble it is recommended to use only the drawers offered in the Euro-500TX
Handy distribution network.
1. Turn the ECR off.
2. Ready the ECR drawer.
3. Remove the original connector.
4. Press the new connector as shown in the figure.
5. Plug the drawer connector into the rear connector panel for external devices.
6. Turn the ECR on and check the drawer functionality (e. g. press "Drawer open" in the registration
or training mode, event. use test #600).
Note 3: The drawer opens automatically only if the ECR is externally powered.
Top view Front view
4 3 2 1
ECR drawer cable
Fig. 4.21 Modular jack 4×4 connexion
Service manual
4 3 2 1
1 4

Fig. 4.20 Connection of the external ECR drawer

© Elcom, s. r. o.
47