Motor Reinstallation; Fig. 4.7 Motor Reinstallation; Fig. 4.8 Bottom View Of Motor Cover; Tab. 4.5 Table Of Shown Parts - ELCOM Euro-500 Handy Series Service Manual

Euro-500TX Handy

4.4 Motor reinstallation

1. Make sure that the ECR is turned off and the external power supply is disconnected. Separate the
front and middle cover from the bottom one (chapter 4.1)
2. Unplug the motor connector (W–M) from the main PCB.
3. Remove the motor cover from the bottom one by unfastening the screws.
4. Turn the motor cover and release the fixing screws of the motor itself.
5. Pull the motor out from its fixation ribbing (direction ridges).
6. Re-solder the motor connector — red wire onto the + motor pin if necessary.
7. Place the new motor into the fixation ribbing and position the motor holders.
8. Tighten the fixing screws so as to catch the motor holders in place.
9. Assemble the front and middle cover back onto the bottom one.
1
2
Index Quantity
1 2
2 1
3 1
4 1
5 4
6 2
7 1

Tab. 4.5 Table of shown parts

38
Service manual

Fig. 4.7 Motor reinstallation

Description
Motor cover screw 2.9×9.5
Winding roll
Motor cover
Under cover
Screw 2.9×6.5
Motor holder
Euro 500 Handy winding motor
3
3

Fig. 4.8 bottom view of motor cover

4
Code
M250018
M040010
M040189
T16H500
M250017
M050081
T02H500
© Elcom, s. r. o.
5
6
7