Performance Testing / Quality Control 12.1 Introduction; Optimizing For Maximum Performance; Instrument Location - tecan sunrise RC Technical Manual

12. Performance Testing /
Quality Control
12.1 Introduction

12.2 Optimizing for Maximum Performance

12.2.1 Instrument Location

2004-10 Technical Manual for sunrise RC, TW, TS, TC, BC, 6F No. T 137 302 Rev No. 1.1
If at any time the analytical performance of the
user should follow the instructions given for quality control or contact
Before starting measurements, make sure that the microplate position
This chapter gives the instructions on how to obtain the best performance and
accuracy from this instrument.
Also included are instructions on how to easily check the performance of the
instrument.
The instrument has been fully factory tested to ensure that its performance is
within the specified limits.
Experience has shown that operating technique and laboratory conditions cause
the greatest amount of inaccuracy.
The greatest accuracy can be obtained from the instrument by observing the
recommendations below:
The instrument should be placed on a level, flat surface that is free from dust,
solvents and acidic vapors.
The instrument must be protected from vibrations and direct light, particularly
sunlight.
When performing the measurements, always close the plate support cover to
ensure that the results are not effected by any external light.
12. Performance Testing / Quality Control
Caution
the local service center.
Caution
A1 is inserted correctly.
sunrise
is questioned the
12-1