Yamaha YZF-R1 98 Service Manual page 257

CARBURETORS
3. Install:
• pipes
• fuel feed pipes
• vacuum cham ber pipe
• vacuum cham ber air vent hose
• springs
• float cham ber air vent hoses
• hose joints
• spacers
• copper w asher
• connecting bolts
NOTE:
• Do not tighten the connecting bolts,
yet.
• Install the throttle valve lever 1 onto
carburetors #1, #2, and #4 betw een the
spring 2 and synchronizing screw 3.
4. Install:
• starter plunger link 1
NOTE:
Install the starter plunger link 1 onto
each starter plunger.
5. Tighten:
• connecting bolts
NOTE:
• Place the carburetor assem bly on a
surface plate w ith the intake m anifold
side dow n. Then, tighten the connect-
ing bolts w hile pushing dow n the car-
buretor assem bly w ith an even force.
• After tightening the connecting bolts,
check that the throttle valve lever and
starter plunger link operate sm oothly.
6. Install:
• starter cable 1
NOTE:
Install the starter cable holder 2 onto
the starter cable.
6 - 9
CARB
7 Nm (0.7 m · kg)