Removing The Front Door And Air Intake Assemblies - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
This section includes the following topics:
•
•

Removing the Front Door and Air Intake Assemblies

When you remove the front door and air intake assemblies, you remove the door, air intake assembly,
and the hardware used to hold those components to the chassis.
To remove the front door and air intake assemblies on the Cisco Nexus 7018 chassis, follow these steps:
Step 1 Remove the front door by following these steps:
a.
Figure 9-33
1
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-62
Removing the Front Door and Air Intake Assemblies, page 9-62
Replacing the Air Filter on the Cisco Nexus 7010 Chassis, page 9-80
Open the door by pulling one of its latch handles out until it clicks (the handle clicks when you pull
it out about 30 degrees) and rotating the door away from the chassis (see Callouts 1 and 2 in
Figure 9-33).
Opening the Front Door
Open one of the two latch handles until it clicks.
Chapter 9 Replacement Procedures
2
Swing open the door.
OL-23069-06