Installing The Air Filter - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Hide thumbs Also See for Nexus 7000 Series:
Table of Contents

Advertisement

Chapter 3
Installing a Cisco Nexus 7010 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m

Installing the Air Filter

You can install the optional air filter while the Cisco Nexus 7000 Series system is operational.
Note
Only the Cisco Nexus 7010 switch includes an optional air filter.
To install an air filter, follow these steps:
Align the air filter to the EMI panel, which covers the air intake area.
Step 1
Use one hand on the air filter to hold it in place while you use the other hand to pull out the spring pin
Step 2
on one side of the air filter. Adjust the air filter so that the spring pin will be released into its hole in the
EMI panel bracket.
Switch hands to hold the air filter on the EMI panel and use the free hand to pull out the other spring pin
Step 3
on the other side of the air filter. With the spring pin pulled out, position the air filter so that the pin will
be released into its hole on the EMI panel bracket. Release the spring pin and make sure that it holds the
air filter on to the EMI panel.
Screw in and tighten both captive screws, one on each side of the air filter.
Step 4
OL-23069-06
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Air Filter
3-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nexus 7009Nexus 7018Nexus 7010

Table of Contents