Connecting Your Esd Wrist Strap To The Chassis - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Chapter 3 Installing a Cisco Nexus 7010 Chassis
Grounding the Cisco Nexus 7010 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-7 Grounding Pad on the Rear of the Cisco Nexus 7010 Chassis
1 Grounding pad
Step 5 Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site
to ensure an adequate earth ground for the switch. If the rack is grounded, connect the grounding wire
as explained in the documentation provided by the vendor for the rack.

Connecting Your ESD Wrist Strap to the Chassis

After you connect the chassis to the data center earth ground, you can ground your ESD wrist strap by
plugging it into any one of three ESD ports shown in Figure 3-8 (front of the chassis) or Figure 3-9 (rear
of the chassis).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-14
OL-23069-06