Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 267

Chapter 9 Replacement Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Realign the EMI panel to the air intake area on the chassis and tighten its four captive screws to
d.
8 in-lb (0.9 N·m).
Remove the front doors by following these steps:
Step 2
Unscrew the three screws that hold one door frame assembly to the chassis until the screws are no
a.
longer in the chassis. Remove the door assembly from the chassis. See
Repeat step 4a for the other door assembly.
b.
Figure 9-18
1 On each door frame, loosen three captive screws
and remove the door frame from the chassis.
OL-23069-06
Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
Removing the Front Door Assemblies
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Figure 9-18.
9-45