Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 369

Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure E-4 Packing AC Power Supply Units in a Cisco Nexus 7018 Multi-Unit Box
1
2
3
4
b.
c.
d.
OL-23069-06
Open the power supply box.
Make sure that the bottom pad and
cardboard holders are in place in the box.
Place AC power supply units in
alternating slots (leave at least one slot
empty between power supply units).
Coil the power cords and place them in
the slots next to their power supply units.
Make sure there is a packing cushion below the cardboard holder (see Callout 2 in
Loosen the four captive screws on the power supply unit so that they no longer connect with the
chassis.
With one hand on the handle of the power supply unit, pull the unit partially out of the chassis.
5 Place the top pad on top of the power supply units.
6
Fold the narrow flap over the top of the top pad.
7 Fold the wide flaps over the folded narrow flaps.
8 Tape the wide flaps together and to the box with
packing tape.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Repacking the System Components
Figure E-4).
E-13