Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 381

Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
1
Open the box.
2
Insert the front door box into
the main box.
3 Insert the air intake frame
box next to the front door box
and at the bottom of the main
box.
4
Place the bottom hinge
bracket box on top of the air
intake frame box.
5
Place two filler boxes on top
of the bottom hinge bracket
box.
Step 10 Remove and repack the cable management system by following these steps:
Loosen and remove the eight M4x8 pan-head screws that fasten the top cover to the upper cable
a.
management assemblies and chassis (see
Figure E-14
1
Four M4x8 pan-head screws fastened to the
chassis
Remove the top cover from the chassis and the two upper cable management assemblies.
b.
OL-23069-06
6
Place the bag of small parts bag in one of the filler boxes
7
Fold the two short flaps over the top of the box.
8 Fold the two long flaps over the top of the short flaps.
9
Tape the tow long flaps together and to the box with packing
tape.
Detaching the Top Cover from the Upper-Cable-Management Assemblies and Chassis
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Figure E-14).
2
Four M4x8 pan-head screws fastened to the
two upper cable management assemblies
Repacking the System Components
E-25