Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 353

Appendix D Chassis and Module LEDs
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Table D-2
LED
ACT
ACT LOG
FLASH
ACT
EXPANSION
FLASH
CMP MGMT
ETH
CMP
STATUS
LINK
ACT
Table D-3
Table D-3
LED
ID
OL-23069-06
Supervisor Module LEDs (continued)
Status Description
Flashing The module is transmitting or receiving.
green
Off The module is not transmitting or receiving.
Green The log flash CompactFlash is being accessed. Do not remove the
Compact Flash until the LED is off.
Off The expansion flash CompactFlash is not being accessed. You can remove
the CompactFlash while this LED is off.
Green The expansion flash CompactFlash is being accessed. Do not remove the
Compact Flash until the LED is off.
Off The log flash CompactFlash is not being accessed. You can remove the
CompactFlash while this LED is off.
Green The management port is operational.
Amber The management port link has been disabled through the software.
Flashing The management port link is bad and has been disabled due to a hardware
amber failure.
Off The module does not detect a signal.
Green All diagnostics pass. The CMP is operational (normal initialization
sequence).
Amber Sufficient power is not available for all modules.
Flashing The diagnostic test has failed.
amber
or
The CMP is not operational because a fault has occurred during the
initialization sequence.
Red The module has detected a slot ID parity error.
Off The CMP is not receiving power.
Green The module has detected a link.
Off The module has not detected a link.
Flashing The module is transmitting or receiving.
green
Off The module is not transmitting or receiving.
describes the I/O module LEDs.
I/O Module LEDs
Status Description
Blinking The operator has activated this LED to identify this module in the chassis.
blue
Off This module is not being identified.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
D-3