Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 124

Installing the Front Door and Air Intake Frame
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 4-16
1
Four M4x8 pan-head screws that fasten the
hood to the chassis.
Step 5 Tighten the four M4x8 screws that fasten the hinge bracket to the chassis to 11 to 15 in-lb (1.2 to
1.7 N·m).
Step 6 Tighten the four M4x8 screws that fasten the hinge bracket to the cable management frame to 11 to
15 in-lb (1.2 to 1.7 N·m).
Step 7 Fasten the four ball-point studs (51-5008-01), each one with a washer (49-0430-01), to the bottom
portion of the chassis, one stud by each corner of the air intake area as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
4-24
Attaching the Hinge Bracket to the Cable Management Frame and Chassis
Chapter 4 Installing a Cisco Nexus 7018 Chassis
2
Four M4x8 pan-head screws that fasten the
hood to the left and right cable management
assemblies.
Figure 4-17.
OL-23069-06