Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 116

Installing the Cable Management Frame
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
To install the cable management assemblies on the Cisco Nexus 7018 switch chassis, follow these steps:
Attach a lower cable management assembly (800-31343-01) onto the two hooks that protrude from the
Step 1
lower half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in
Figure 4-8
1 Lower cable management assembly. 3
2 Rack-mount bracket.
Repeat Step 1 to attach a lower cable management assembly to the right side of the chassis.
Step 2
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
4-16
Attaching a Lower Cable Management Assembly to a Rack-Mount Bracket
Chapter 4
Position the assembly so that the two lower hooks on
the rack-mount bracket fit inside the two holes on the
assembly, and then slide the assembly down so that it is
held by the hooks.
4 Loosely fasten the assembly to the rack-mount bracket
with four M4x10 screws. Do not tighten these screws.
Installing a Cisco Nexus 7018 Chassis
Figure 4-8.
OL-23069-06