Reloading Modules
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Xb4
Xb5
fan1
fan2
fan3
fan4
N/A - Per module power not available
Power Usage Summary:
--------------------
Power Supply redundancy mode (configured)
Power Supply redundancy mode (operational)
Total Power Capacity (based on configured mode)
Total Power of all Inputs (cumulative)
Total Power Output (actual draw)
Total Power Allocated (budget)
Total Power Available for additional modules
switch#
Reloading Modules
You can reload the entire switch, reset specific modules in the switch, or reload the image on specific
modules in the switch.
This section includes the following topics:
•
•
Reloading the Switch
To reload the switch, use the reload command without any options. When you use this command, you
reboot the switch.
If you need to use the reload command, be sure to save the running configuration by using the copy
Note
running-config startup-config command beforehand.
Power Cycling Modules
To power cycle any module, follow these steps:
Identify the module that needs to be reset.
Step 1
Reset the identified module by entering the reload module command. This command power cycles the
Step 2
selected module.
switch# reload module number
The number indicates the slot in which the identified module resides.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
7-28
N7K-C7010-FAB-1
N7K-C7010-FAB-1
N7K-C7010-FAN-S
N7K-C7010-FAN-S
N7K-C7010-FAN-F
N7K-C7010-FAN-F
Reloading the Switch, page 7-28
Power Cycling Modules, page 7-28
Chapter 7
N/A
60 W
Powered-Up
N/A
60 W
Powered-Up
88 W
720 W
Powered-Up
88 W
720 W
Powered-Up
9 W
120 W
Powered-Up
9 W
120 W
Powered-Up
Redundant
Redundant
Managing the Switch Hardware
9000 W
18000 W
2259 W
4750 W
4250 W
OL-23069-06