Connecting Or Disconnecting A 1000Base-T Port; Connecting A 1000Base-T Port To The Network - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Connecting an I/O Module
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Table 6-1 Connectors and Cables Supported by I/O Modules (continued)
Module
32-port 1- /10-Gigabit Ethernet (N7K-F132XP-15)
8-port 10-Gigabit Ethernet (N7K-M108X2-12L)
1. FETs are used only when connecting this I/O module to a Fabric Extender (FEX).
2. Requires Version 2 or later version.
3. Requires Version 2 or later version.
This section includes the following topics:
•
•

Connecting or Disconnecting a 1000BASE-T Port

This section includes the following topics:
•
•

Connecting a 1000BASE-T Port to the Network

You can connect a copper network interface cable with an RJ-45 connector to a port on a 48-port
10/100/1000 Ethernet I/O module (N7K-M148GT-11 and N7K-M148GT-11L).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
6-8
Connecting or Disconnecting a 1000BASE-T Port, page 6-8
Connecting or Disconnecting an SFP, SFP+, or X2 Port, page 6-9
Connecting a 1000BASE-T Port to the Network, page 6-8
Disconnecting a 1000BASE-T Port from the Network, page 6-9
Chapter 6 Connecting the Cisco Nexus 7000 Series Switch to the Network
Port Type Connector/Transceiver
SFP GLC-LH-SM
GLC-LH-SMD
GLC-SX-MM
GLC-SX-MMD
GLC-ZX-SM
SFP-GE-L
SFP-GE-S
SFP-GE-Z
1000BASE-T GLC-T
SFP-GE-T
SFP+ SFP-10G-LR
SFP-10G-LRM
SFP-10G-SR
SFP-H10GB-CUxM
SFP-H10GB-ACUxM
10GBASE-X X2-10GB-ER
X2-10GB-LR
X2-10GB-LRM/
X2-10GB-LX4
X2-10GB-SR
X2-10GB-ZR
X2-10GB-CX4
X2 DWDM-xxxx
Cable Type
Fiber optic
Copper
2
Fiber optic
2
Copper
Fiber optic
Copper
Copper
OL-23069-06