Tape Loading - Upper Taping Head; Tape Loading - Lower Taping Head - 3M -Matic 7000a-I Instructions And Parts List

Operation
(continued)
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fingers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
It is recommended that the detailed
instructions and sketches in this manual
be referred to the first few times the
taping head is loaded/threaded until the
operator becomes thoroughly familiar
with the tape loading operation.
Note – Remove tape roll before removing
Tape Loading – Upper Taping Head
1.
2. Use Figures 3-3/3-5 and tape thread-
3. Attach the threading needle to the
4. Continue pulling the threading needle
5. Pull threading needle down until tape
6. Cut away any excess tape.
Important – Do not cut against apply
roller - roller damage could occur.
Tape Loading – Lower Taping Head
1. Remove the lower taping head from
2. Lower taping head is loaded and
3M-Matic Accuglide 3 - 2 Inch Taping Head - Type 10800
™
Page 10
44-0009-2070-0 / ECO#0078483
Warning
taping head from machine to
minimize weight.
Place the upper taping head in a
convenient working position.
ing label. Position tape roll so adhesive
side of tape faces front of taping head
as it's pulled from supply roll.
end of the roll. Guide the threading
needle around the wrap roller
(Position 1) then back around the
one-way tension roller (Position 2).
down and guide it between the two
rollers on the apply arm (Position 3).
travels between apply plate and ears
of apply arm (Position 4) until extends
past apply roller. When threaded adhe-
sive side of tape should face knurled
rollers at position 2 and also position 3.
the conveyor bed or associated
equipment and place it a convenient
working position.
threaded in same manner as upper head.
Source Document for all related Manuals/Translations
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
• To reduce the risk associated with
muscle strain:
- Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift
• To reduce the risk associated with
impact hazards
- Place the taping head on a smooth
level surface when maintaining or
servicing this equipment
Figure 3-3
Insert threading needle through rollers in
direction indicated by arrows.
Figure 3-3 Tape Loading/Threading
Original Instructions
Warning
Caution
One-Way
Tension
Roller
Tension
1
2
Wrap
Roller
Knurled
Roller
Wrap
3
Roller
Applying
Roller
4
International - ENG
February 2021