Devices And Chains - Front Panel Control; Devices; Building Chains On The Fly - Solid State Logic Matrix2 Delta Owner's Manual

Devices and Chains - Front Panel Control

Your 16 pieces of outboard gear that are connected to the Insert Send and Returns connections can be routed to the desired
Insert Point from the front panel. Equally, any change you make in the Matrix Remote browser, will be mirrored on the Matrix
itself.
Pressing the

DEVICES

OI] [MPP LMNEGO XLI 0'( WGVMFFPI WXVMT
on the right-hand side of Matrix to display the names of your
16 pieces of analogue outboard gear.
The two rows of eight buttons above and below the labels will
indicate if that particular
If the button is lit (yellow) that device is available. If the button
is not lit, it is already inserted across a channel.
From this point, you can route outboard gear to each channel. Simply press the upper
want to insert something on and then press of the button corresponding to the device you want to insert.
That button will now unlight and the text will appear on the main LCD display, underneath the channel name. You
Bass
can follow the same procedure to insert devices on other channels.
1176

Building Chains On The Fly

The Matrix will allow you to use up to 6 devices across a single channel's insert point. With the
go to a channel where you already have a single device insert across a channel. For example, we already have our "1176" device
inserted on the Bass channel but we want to put a "4K EQ" after it. To do this, we use the Navigation arrows.
QSZI HS[R XS XLI RI\X EZEMPEFPI WPSX [LIR ]SY LEZI ½PPIH XLI GYVVIRX WPSX 8LI FSXXSQ VMKLX SJ XLI
a small dot '.' to indicate when a particular channel has a device inserted on the next slot down.
The left and right arrows will allow you to move the upper
upper SEL key directly).
DEVICE is available.
Press the DOWN arrow. Where the text displayed "1176", you will now see a "*". This indicates
the slot is available and all you need to do is press one of of the 16 devices corresponding to the
device you want to insert.
To further aid recognition of what you are doing, the two character
display will change to read
that that channel.
The up and down arrows will allow you to move between slot numbers on a channel. You can only
Please note that if the
the DEVICES
as V-SOLO
Chapter 5 for more information on these modes.
Devices
1176 LA-3A
9KDYN LA-2A
"- 2² 8LMW WMKRM½IW XLEX ]SY EVI SR XLI WIGSRH WPSX SJ
SEL OI] XS WIPIGX XLI GLERRIP ]SY [ERX SV NYWX TVIWW XLI HIWMVIH
Chapter 3 - Analogue Signal Flow
IN-LINE
and CHAINS buttons will function
and V-MUTE commands instead. See
DIST 4KDYN MANL VHD
THERM VULT DIST 9KEQ
SEL key on the channel you
DEVICES
MODE
MODE
Matrix 2 Owner's Manual
button is active,
1176 4KDYN
PURP LA-2A
button still active,
- 2
MODE
display will display
42