Step 1: Bringing Signal Into The Channel - Solid State Logic Matrix2 Delta Owner's Manual

STEP 1: Bringing Signal into the Channel

In this step, we will simply learn how to bring signal into the channel from the D-connectors on the Matrix back panel.
³ First, ensure that the desk is in Analogue Focus mode, not DAW Focus mode, by checking that the Focus
button (shown right) is lit.
³ Press the upper
SEL
now assigned to channel 16.
2SXI 8LIVI MW E WIGSRH
MW EWWSGMEXIH [MXL (%; GSRXVSP RSX EWWMKRMRK XLI 1EWXIV 'LERRIP 8LI (%;
³ Find the
INPUT FLIP
feeding the channel: the main (line-in) input, or the DAW return. Make sure the button is lit green, indicating that the main
input is selected. If it is red, indicating that the DAW return is selected, press it to select the main input.
In the channel strip, the LEDs to the right of the grey gain pot labelled
indicate the input selection:
³
9WI XLI KEMR TSX XS EHNYWX XLI KEMR SJ XLI MRTYX =SYV '( WMKREP WLSYPH RS[ FI WLS[R MR XLI QIXIV EFSZI
XLI GLERRIP WXVMT ERH ]SY GER YWI XLMW XS EHNYWX MXW PIZIP
³
Lift the channel fader to 0dB and check that neither the
We will examine these controls in Step 7.
2SXI =SY [SR´X LIEV ]SYV WMKREP YRXMP 7XIT 
key on Channel 16. It will light to indicate that it is selected. The Master Channel is
SEL FYXXSR MR XLI GLERRIP PSGEXIH E PMXXPI PS[IV SR XLI GLERRIP WXVMT NYWX EFSZI XLI JEHIV 8LMW FYXXSR
button at the top of the Master Channel. This button determines which of the two channel inputs is
INPUT
SEL
or DAW.
Chapter 2 - Getting Started
FYXXSR MW I\EQMRIH SR 4EKI 
CHIP (at the top of the channel) also
SOLO nor CUT buttons above the fader are lit.
Matrix 2 Owner's Manual
18