Solid State Logic Matrix2 Delta Owner's Manual page 44

FX Sends
Matrix has four mono FX sends. Only two FX busses can be fed at any one time by a
particular channel, using the two gain pots (which have Total Recall LEDs). By default,
the sends to FX busses 1 and 2 are active. Pressing the
Channel switches the
routing is indicated by the
pressing the
FX2 bus to the FX4 bus, and this routing is indicated by the
gain pot being lit.
Pressing the gain pot switches the send on and off. The
The FX sends are fed post-fader by default, but have two alternative sources: the pre-fader (post-insert) signal and the
8MT 7MKREP TVSGIWWMRK GER FI EHHIH XS WXIVIS GYI WIRHW [LIR XLI] EVI FIMRK YWIH EW EHHMXMSREP QM\HS[R GLERRIPW WII
TVIZMSYW TEKI F] WSYVGMRK XLI *< FYWWIW JVSQ XLI
8MT ;LIR YWMRK 7YTIV'YI WII TVIZMSYW TEKI  ]SY GER EZSMH WYHHIR PSWW SJ XLI *< WIRHW WMKREP TVSGIWWMRK MR XLI
MONITOR HYVMRK HVSTMRW F] WSYVGMRK XLI *< FYWWIW JVSQ XLI
The source is selected using the
LEDs above and to the right of the send gain pot, as well as by the colour of the
Signal Source
Post-fader (default setting)
Pre-fader
Stereo Cue Send
When an FX3 or FX4 bus is pressed, the source selection and gain for that signal feed remain unchanged.
FX1/3 signal feed from the FX1 bus to the FX3 bus, and this
FX3 LED to the right of the gain pot being lit. Similarly,
FX4 button in the Master Channel switches the
SRC button in the FX1/3
LED indication
No LED
PRE
CUE
FX3
FX2/4
FX4
ON LED below the pot will light to indicate that it is on.
CUE FYW
CUE FYW
and FX2/4 sections of the Master Channel, and is indicated by the
SRC button colour
is lit
is lit
Chapter 3 - Analogue Signal Flow
button in the Master
signal feed from the
LED to the right of the
SRC button:
Unlit
Green
Red
Matrix 2 Owner's Manual
CUE bus.
ARTIST
36