Step 2: Routing To The Main Busses - Solid State Logic Matrix2 Delta Owner's Manual

Chapter 2 - Getting Started

STEP 2: Routing to the Main Busses

Having brought signal into the channel, we will now learn how to bring it out again. We will cover more of the channel output
options in Steps 4 and 7.
³ Press the
This routes the signal to the record bus. The button will light red to indicate that
this routing is active. Your CD signal should now be shown in the
the right of the VU's above the centre section.
³ %HNYWX XLI PIZIP SJ XLI VIGSVH FYW YWMRK XLI KVI] KEMR TSX MR XLI QEMR
right of the centre section (shown left).
There are two ways to route the signal to both record and mix busses:
*MVWXP] [I [MPP VSYXI NYWX XLMW GLERRIP XS FSXL FYWWIW
³ Press the
MIX button, below the
Your CD signal should now be shown in the
Secondly, we will route the whole record bus to the mix bus:
³ So as not to double the routing, deselect the mix bus routing from the channel by pressing
³ In the
REC area of the centre section, press the
is active.
8LI QM\ FYW PIZIP MW EHNYWXIH MR X[S TPEGIW
³ Lift the master fader, to the right of the channel faders, to 0dB.
³ Turn the gain pot in the main
distinguish the mix bus from the record bus in the following step, leave the mix bus level about 20dB lower
than the record bus level.
19
Matrix 2 Owner's Manual
REC button in the BUS
REC button in the Master Channel. It will light yellow to indicate that this routing is active.
MIX meter, to the right of the VU's above the centre section.
TO MIX
MIX
area towards the bottom of the Master Channel.
button. The LED next to it will light to indicate that this routing
bus controls, located to the left of the
REC meter, to
REC bus controls, located in the top-
MIX again.
REC bus controls. In order to