Step 3: Hearing Your Signal - Solid State Logic Matrix2 Delta Owner's Manual

STEP 3: Hearing your Signal

In this step we will set some basic monitoring using the
Master Channel.
³ Check that the large blue pot marked
have switched on your main monitors!
³ Press the
REC button, to the right of the large pot. It will light red to indicate that you have
selected the record bus for monitoring. Your CD signal should now be shown in the
to the right of the VU's above the centre section.
³ Turn the monitor volume up using the
³ If you can't hear anything, check that the
unlit, indicating that the mix is neither dimmed nor cut.
³ If you still can't hear anything, press the
area. This clears any solos that might have been activated.
³ If there's still no sound, check your connections and go back to Step 1!
³ Still in the
MAIN MONITORING
The REC button's light will go out and the
mix bus. Because you have set the mix bus level lower than the record bus, this action should cause the monitoring volume
to drop. You may want to increase the mix bus gain now, so that you can hear the mix bus clearly for the rest of the tutorial.
³ Press the
DIM button below the main volume. This makes the monitoring immediately quieter, and the button lights to
indicate that it is active.
³ %HNYWX XLI QMHHPI SJ XLI XLVII WQEPPIV KVI] TSXW QEVOIH
³ Press the
DIM button again to cancel it.
³ Now press the
CUT
Press the CUT button again to cancel it.
MONITOR LEVEL
MONITOR LEVEL
DIM
SOLO CLEAR
area, press the
MIX
button. This makes the monitoring immediately silent, and the button lights to indicate that it is active.
MAIN MONITORING
is not turned up too high and that you
pot until you can hear your CD.
and CUT buttons beneath the monitor volume are
button in the top right of the monitoring
MIX button, located below the
button will light yellow to indicate that you have switched to monitoring the
DIM XS HI½RI LS[ QYGL HMJJIVIRGI XLMW FYXXSR QEOIW
Chapter 2 - Getting Started
area of the centre section, to the right of the
MON meter,
REC button in the monitoring section.
Matrix 2 Owner's Manual
iJack
DIM CUT
20