Configuring Cc Layers - Solid State Logic Matrix2 Delta Owner's Manual

Configuring CC Layers

;LIR E '' 4VS½PI MW EWWMKRIH XS E 1EXVM\ PE]IV '' QIWWEKIW EVI WIRX SR 'LERRIP  SJ XLI ½VWX WIRH TSVX EWWMKRIH XS XLEX PE]IV
These messages can be used to control software instruments within the current DAW, using the DAW's MIDI 'learn' mode to
attach the Matrix controllers to instrument plug-in parameters. Alternatively, an external hardware MIDI device can be controlled
by assigning it to the output of a MIDI track in the DAW whose input is receiving the control data from a Matrix CC layer. Logic
provides a further mechanism to integrate external MIDI hardware via the capabilities of the Logic Environment.
CC Layers are unidirectional. No CC data is returned from the device to Matrix and all front panel positional indication is derived
locally, not from the device itself. Matrix controls are mapped to CC numbers as follows:
- Faders 1-16:
- V-Pots 1-16:
- SEL switches 1-16:
- V-Sels 1-16:
Faders and V-Pots output the full range of controller values 0-127.
2SXI XLEX XLI :4SXW JYRGXMSR EW EFWSPYXI GSRXVSPPIVW RSX EW MRGVIQIRXEP HIZMGIW
The SEL and V-Sel switches emulate latched switches sending appropriate ON and OFF values as they change state:
- ON = 127,
- OFF = 0.
The ON state is indicated by the switch tally: The V-Sel switch uses the red led located beneath the V-Pot, and the
uses the light in the switch and the
4PIEWI VIJIV XS ]SYV 1-(- HIZMGI´W QERYEP JSV MRWXVYGXMSRW VIKEVHMRK QETTMRK XLIWI '' RYQFIVW [MXLMR XLI 1-(- HIZMGI
CC's 0-15
CC's 16-31
CC's 64-79
CC's 80-95
SEL symbol in the meter bridge.
Chapter 6 - DAW and CC Configuration
Matrix 2 Owner's Manual
SEL switch
117