Solid State Logic Matrix2 Delta Owner's Manual page 124

Chapter 6 - DAW and CC Configuration
Foot Switch Commands
The Foot Switches buttons in the middle of the
can be connected to the Matrix to have any USB or listed DAW command assigned to them. Both the HUI and MCU protocols
contain dedicated codes for use with foot switches which actuate the DAW transport Play and Record functions. These are
shown in the command list as
-R EHHMXMSR XLIVI MW ER I\XVE 770 GSQQERH [LMGL LEW FIIR GVIEXIH WTIGM½GEPP] JSV YWI [MXL XLI JSSX W[MXGL
Switch enables the talkback function of the
2SXI XLEX XLI JSSX W[MXGL QYWX FI LIPH HS[R XS OIIT XEPOFEGO STIR
KVM Hot Key
The KVM Hot Key, located towards the top left of the
The button is only used on setups where there is more than one computer connected to Matrix. The
programmed with a command to a USB KVM switch, telling it to switch between computer ports. When programmed, it outputs
a USB command whenever its layer is selected using the console's
WIPIGX XLI 97& TSVX GSRRIGXMRK XS XLI GSQTYXIV SR [LMGL XLI PE]IV´W (%; SV 1-(- HIZMGI MW LSWXIH 8LI WTIGM½G GSQQERHW
used by your KVM switch should be found in its operating manual.
116
Matrix 2 Owner's Manual
Transport/Utility
Play Foot Switch and Record Foot
Artist button to be assigned to a foot switch.
window allow the two momentary foot switches which
Switch.
Transport/Utility window, does not appear on the Matrix console.
DAW LAYER SELECT
Artist Talkback
KVM Hot Key
buttons, telling the KVM switch to
can be