Chapter 2 - Getting Started
STEP 8: Setting up Artist and Control Room Headphones
You can control the mix your musicians hear from the
area, shown below.
You can listen to the artist's mix using the desk's own headphone output:
³ Plug your headphones into the desk's headphone socket, located in the trim on the right-hand side of the desk.
³ In the
HEADPHONE
This routes the artist's mix, rather than the main monitor mix, to the desk's headphones and it will light
to indicate that this routing has been selected.
³ =SY GER EHNYWX XLI LIEHTLSRI PIZIP YWMRK XLI
We will use the stereo cue bus to create our artist's headphone mix:
³ In channel 16, press the
The LED below it and to the right will light to indicate that it is on.
³ 9WI XLI TSX XS EHNYWX XLI KEMR YWMRK XLI
upper pot.
³ In the
ARTIST MONITOR
CUE ST
output as the send to the artist's headphones. You will see the other source options available, shown above and
below the
CUE
button.
³ %HNYWX XLI EVXMWX´W LIEHTLSRI PIZIP YWMRK XLI KVI] KEMR TSX MR XLI PS[IV VMKLXLERH GSVRIV SJ XLI
³ Press the button marked EQ, towards the top right, which inserts a 2-band EQ into the artist's send.
³ %HNYWX XLI )5 YWMRK XLI
³ Press the
MONO
button to sum the send to mono. Press it again to restore the send to stereo.
=SY GER XEPO XS ]SYV QYWMGMERW YWMRK XLI XEPOFEGO QMG =SY GER EHNYWX XLI PIZIP SJ XLI XEPOFEGO QMG YWMRK XLI
pot, located above the
MAIN MONITOR
³ Holding down the
centre section, routes the talkback mic to the artist's headphones.
ARTIST
25
Matrix
2
Owner's Manual
area below the
ARTIST MONITOR
HEADPHONE
CUE ST
gain pot (the lower of the two
CUE ST
area, press the
HF
and
LF
pots, located above and below the
EVIE WLS[R VMKLX
8LI XEPOFEGO QMG MXWIPJ MW NYWX FIPS[ XLI pot.
ARTIST
2SXI XLEX ]SY [MPP RSX LIEV XLI XEPOFEGO QMG SR XLI HIWO LIEHTLSRI SYXTYX IZIR XLSYKL
ARTIST
MW TVIWWIH EW XLI TMGO SJJ TSMRX MW TVI PIZIP ERH 8& MRNIGXMSR
2SXI XLEX XLI QEMR QSRMXSVMRK EYXSQEXMGEPP] HMQW [LIR XLI XEPOFEGO FYXXSR MW WIPIGXIH
ARTIST MONITOR
area, press the
pot next to the
CUE ST
meter to the right of the VU's as a reference, and pan the signal using the
CUE
button (the fourth one down on the left-hand side). This selects the
button, located in the bottom right-hand corner of the
area, located to the right of the
FROM ARTIST
button.
FROM ARTIST
button.
pots) to switch on the send.
ARTIST MONITOR
EQ
button.
MAIN MONITOR
iJack
area.
TB
FROM
Need help?
Do you have a question about the Matrix2 Delta and is the answer not in the manual?