Nortel 1000E Maintenance Manual page 136

Page 136 of 162
553-3041-500 Standard 1.00
Replacing equipment
7 If the new software daughterboard is the same vintage as the old one, a
Software Delivery Card is not needed for the install. After power up, the
card will come up in the main menu. From the Install menu, select item 1
"New System Installation - From software daughterboard". Proceed to
step 10.
8 If an NTTK25 or a programmed daughterboard of a different vintage is
being used, insert a Software Delivery card with the same release and
issue of software as is being replaced into slot A of the SSC card. The
user can then log into the system.
9 From the main menu, select item 4 "New System Installation - From
Software Delivery Card".
10 Proceed with the Installation Menu choices as described in
Communication Server 1000E: Installation and Configuration
(553-3041-210). When prompted for the choice of database, select item
2 "Basic Configuration".
Note: It is important to choose "Basic Configuration", otherwise the
system can invoke an EDD after loading the new software which can
overwrite the customer data stored on the CPU.
11 Once the software is installed and the system is rebooted, the customers'
backup configuration files must be restored:
• If you use a PC to restore, use the RBK command in LD 143.
• Login and load LD 143.
• Need to perform an upgrade.
• From the Main Menu, select item 3 "Utilities".
• Select item 1 "Restore".
• Select item 1 "Backup Flash Drive".
• Confirm Restore database from the Backup Flash drive.
• Reboot system by setting the power supply off, and then on.
September 2004
End of Procedure