Terminal Module Tm41; Terminal Module Tm54F - Siemens SIMOTION D425 Manual

6.6

Terminal module TM41

Features of the TM41
With the TM41 Terminal Module, the number of available digital inputs/digital outputs and the
number of analog inputs within a drive system can be expanded. In addition, the TTL output
can be used for encoder simulation. The TM41 is connected by means of DRIVE-CLiQ.
The TB41 contains the following terminals:
Table 6- 4
Type
Digital inputs
Digital inputs/outputs
Analog inputs
TTL encoder output
The 50 mm clearances above and below the component must be observed.
Additional references
You will find detailed information about the TM41 terminal module in the
●
●
6.7

Terminal Module TM54F

Features of the TM54F
The Terminal Module TM54F is a terminal expansion module for snapping on to a DIN EN
60715 mounting rail. The TM54F offers safe digital inputs and outputs for control of Safety
Integrated functions of SINAMICS. The Terminal Module TM54F is supported by SIMOTION
D4x5 from version V4.1 SP1 and higher.
Exactly one TM54F, which is connected via DRIVE-CLiQ, can be assigned to each drive
control (SINAMICS Integrated of a D4x5, CX32, CU320, etc.). Each drive control must have
its own dedicated TM54F.
Additional nodes (e.g. TMxx, SMxx, MMxx) can be connected to the same DRIVE-CLiQ line.
TM54 is equipped with the following terminals:
D4x5
Manual, 05/2009
TM41 interface overview
CAUTION
Supplementary SINAMICS System Components for SIMOTION
SIMOTION D4x5
Commissioning and Hardware Installation Manual
Spare parts/accessories
6.6 Terminal module TM41
Quantity
4
4
1
1
Manual
75