Tektronix RTX100A Service Manual page 53

RTX100A ISDB-T RF Signal Generator Service Manual
14. Change the MPEG analyzer to the Play mode.
15. Select File > Open on the MPEG analyzer to display the Open dialog box.
16. In the dialog box, navigate to the E:\MTXRTX_Test streams\
Record_Files, and then select the SPI214Mbps.trp file.
17. On the MPEG analyzer, make the following settings:
Play menu
Data Rate . . .
Update . . . . . .
Source . . . . . .
18. Click the PLAY button on the MPEG Analyzer to start playing the
SPI214Mbps.trp file.
19. Verify that the hierarchic view is displayed on the RTX100A screen. In
addition, verify that the bit rate display is 214 Mbps and the packet size
display is 188 bytes.
20. Press the REC button on the RTX100A to record the file.
21. After recording is completed, click the Stop button on the MPEG analyzer.
22. Exit the MPEG Player application on the MPEG analyzer.
Checking the Recorded File.
23. Change the interface cable connection from DVB/SPI Out connector to
DVB/SPI In connector on the MPEG analyzer.
24. Start the TS Compliance Analyzer on the MPEG analyzer.
25. In the Open Transport Stream dialog box, select Real-time Analysis, and
then make the following settings:
Interfaces . . . . . . . . . . .
Interface Settings
26. Click the OK button.
27. Press the PLAY button on the RTX100A to display the Play screen.
28. Select File > Open to open the Select File dialog box.
29. In the dialog box, navigate to the D:\ Record_Files directory, and then select
the SPI214Mbps.trp file.
30. Select Play > Update > On on the RTX100A.
214 Mbps
Off
RAM
DVB Parallel
. . . . Time Stamping
Performance Verification
3-7