Funkwerk artem ComPoint Butterfly Manual page 66

4-16
• WEP Key Lengths
Select 64 or 128 bits, according to the encryption procedure sup-
ported by your clients. If all clients support 128-bit WEP, you should
use 128 bits.
• Enter WEP Key in
Configure which entry mode you prefer. You can choose between
HEX (hexadecimal entry, characters "0" to "9" and "A" to "F") and
ASCII (all ASCII characters on your keyboard).
• WEP Key 1-4
In the input fields WEP Key 1 to WEP Key 4, you can enter 4 different
WEP keys.
• WEP Key to Use
Select the key (1 to 4) to be used for transmission.
WPA Configuration
Instead of WEP, the WPA-PSK standard which is considered par-
ticularly secure can be used for encryption. Please note that all
subscribers of the wireless network have to support this key.
• Pass Phrase
If you use WPA with PSK (Pre-Shared Key) in your wireless network,
the same pass phrase has to be entered on all devices involved. This
pass phrase is subsequently used for the generation of the keys. It may
have a length between 8 and 63 bytes and may contain ASCII charac-
ters with values between 31 and 127.
Note:
For security reasons, the pass phrase should have a length of at least
20 characters.
• Rekeying Time
Time interval after which a new group key will be generated for all
stations logged on.
802.1x Configuration
This section serves for the configuration of authentication accord-
ing to IEEE802.1x. If you have selected the option WPA Enterprise
under Encryption Method, you have to activate this option and
enter the data for communication with the RADIUS server here. If
The ComPoint in the AP Mode