Funkwerk artem ComPoint Butterfly Manual page 36

2-10
Your ComPoint can now be addressed with its IP address over the
Ethernet via a web browser and/or via Telnet and can be config-
ured.
How to Save and Load a Configuration
The ComPoint Manager, Version 2.08 and higher, offers you the
option to save the configuration of the device and (re)load it, if
required. Please observe that this function can be guaranteed to
run without faults only for Firmware Version 3.10 and higher.
To save a configuration, select the device for which you want to
save the configuration. Subsequently, select Configuration >
Configuration save.
To load a configuration, select the device for which you want to
load the new configuration. Subsequently, select Configuration >
Configuration load.
Note:
Passwords and IP settings which you have already assigned will
not be saved or loaded in this process.
How to Reset a Configuration
1. Select the device for which you want to reset the configura-
tion.
2. Subsequently, select Configuration > Configuration reset.
3. Confirm the following query with OK.
The configuration of the device is reset and the device is restarted.
Note:
If you reset the configuration, the IP settings and the passwords
will be maintained. If you wish to delete the IP settings and the
passwords as well, you have to reset the device to the factory
default settings. Refer to
tory Defaults, Page
The artem ComPoint Manager
Section Resetting the Device to the Fac-
2–20.