Node Table - Funkwerk artem ComPoint Butterfly Manual

The ComPoint in the AP Mode

Node Table

• Current Signal Noise Ratio
Shows the current signal-to-noise ratio in dBm. These values refer to
the last packet that was received.
• Current Signal Level
Shows the current signal level in dBm.
• Current Noise Level
Shows the current noise level in dBm.
• Security
Specifies whether WEP, WPA PSK, or WPA Enterprise encryption has
been activated in the ComPoint.
Provides an overview of all clients (notebooks, desktop PCs,
PDAs, etc.) currently logged on at the ComPoint.
The list of associated clients contains the following information:
• MAC address of the associated clients
• IP address of the associated clients
• Time: Duration of the current session
• Signal in dBm: Current signal strength
• Data rate: Current transmission rate in Mbps
• RX frames: Received frames during the current session
• TX frames: Transmitted frames during the current session
4-3