Funkwerk artem ComPoint Butterfly Manual page 31

The artem ComPoint Manager
After making all settings, click OK to take over these settings.
The Discovery function can be activated both via Devices >
Discovery or directly via the Discovery button in the tool bar.
The ComPoint Manager will then automatically identify the
devices which have been installed in the network and display them
in the main window together with the corresponding parameters
(MAC address, Node name, IP address, IP mode, State). According
to the setting of the options, the working mode (Application), the
firmware version (Version), and the Product name will also be dis-
played.
• IP mode
• static: The IP address of the device was assigned statically. DHCP
has been deactivated on the device.
• DHCP: The IP address of the device was assigned by a DHCP
server. DHCP has been activated on the device.
• Fallback: DHCP has been activated on the device, but the device
has not been assigned any IP address. The address which is auto-
matically set by the device in the case of a fallback corresponds to
the IP address which was statically assigned. If the IP address set in
the delivery state is displayed here (0.0.0.0), you have to assign the
IP address manually under Configuration > IP-Setup.
Note:
If an IP address is assigned manually via the ComPoint Manager and/
or the web/Telnet interface, DHCP is automatically deactivated. This
means that the IP address of the device will no longer be assigned via
the DHCP server as soon as the device has been rebooted.
2-5