Funkwerk artem ComPoint Butterfly Manual page 37

The artem ComPoint Manager
Administrating the Password
Note:
If you reset the configuration, DHCP will be activated on the
device. If you have assigned a static IP address to the device and if
you wish to continue using this address after resetting the config-
uration, you have to deactivate DHCP via the web or Telnet inter-
face under Configuration > Interface.
Function of the Password
The password is required for the following functions of the
ComPoint Manager:
• Load firmware
• Restart
• Factory default
• IP-Setup
• Configuration load
• Password change
• Configuration reset
How to Enter the Password
To enter the password, proceed as follows:
1. Select the device in the list and select Extras > Password.
The following dialog box is opened.
2. Enter the password for the device.
2-11