Run Screens - Graco Informer G3000 Instructions Manual

Run Screens

Screens
Run Run Screens
When in Run Mode, the Informer displays the current
flow rate and batch total on Screen 1. Screen 2
displays the grand total for the flow meter to which it
is connected. Screens 3–6 display a log of the last
20 alarms.
Run Screen Screen 1 1 1
Run Run Screen
Use this screen to view the current batch total and
flow rate, or to reset the batch totalizer to 0. Units are
set on Setup Screen 1 and Setup Screen 2.
Figure 2 Run Screen 1
Enter the screen.
Batch Totalizer - Displays the amount
of fluid measured since the last time the
field was reset to zero.
Flow Rate - Displays the current flow
rate.
Reset Batch Totalizer - resets the batch
totalizer to zero.
Move between Run Screens.
3A2040H
Key Key Key
Run Screen Screen 2 2 2
Run Run Screen
Use this screen to view the grand total flow for the
system. The grand total cannot be reset.
Figure 3 Run Screen 2
Grand Totalizer - Displays the grand
total flow for the system. This value
cannot be reset.
Move between Run Screens.
Run Screens
Key
Key Key
23