AIRTRONICS SD-10G Operating Manual page 97

aero Flight Mode menu
5) The Flaperon mixing percentage values can be changed for each aileron
separately. Press the Navigation Pad 6 to highlight FL 4 LA>100%,
then press the YES/+ or NO/- keys to change the Flaperon 4 Left Aileron
percentage value.
6) Press the Navigation Pad 6 to highlight FL 4 RA>100%, then press the
YES/+ or NO/- keys to change the Flaperon 4 Right Aileron percentage
value.
FL 4 LA and FL 4 RA setting range is -100% to 100%. The default setting is 100%. When the percentage value is decreased
from 100% to 0%, Flaperon travel will decrease in one direction. When the percentage value is decreased from 0% to -100%,
Flaperon travel will increase in the opposite direction.
FL 4 LA and FL 4 RA percentage values will vary based on the NOR/REV Adjustment Value of the two aileron servos when
set up in the Surface menu. For example, depending on the NOR/REV status of the aileron servos, increasing the percentage
values may cause the Flaperons to move up (Spoilerons), instead of down (Flaperons).
IMPORTANT Adjusting the FL 4 LA and FL 4 RA percentage values changes the percentage of Flaperon travel in relation to
the flap channel End Point Adjustment. For example, if the flap switch Flap Position 2 End Point Adjustment is set to 100%
and the Flaperons move down 2", changing the FL 4 LA and FL 4 RA percentage values to 50% will cause the Flaperons to
move down 1". In addition, changing the FL 4 LA and FL 4 RA percentage values to -50% will cause the Flaperons to move up
1" (Spoilerons).
Ailvator Mixing
The Ailvator Mixing function mixes ailerons and elevator, allowing you to have both roll control and pitch control on the elevator,
separate from the ailerons. When Activated, not only will the two elevator halves move up and down together, but each elevator
half can move up and down independently like ailerons. This function is commonly referred to as tailerons (or stabilators), and
is normally found on aircraft that feature full-flying stabilizers.
To be able to Activate Ailvator mixing, your model must feature two separate elevator servos (one servo controlling each
elevator half) and TAIL>2xEL must be selected in the SYSTEM 4 TYPE menu.
IMPORTANT In order for the Ailvator mixing function to work as intended, one of the elevator servos must be reversed
(using the NOR/REV setting in the Surface menu), so that both elevator servos move the same direction up and down.
1) Press the Navigation Pad 56 to highlight MIXING, then press the ENTER key to display the MIXING menu. The FLAPERON
sub-menu will be highlighted by default.
2) Press the Navigation Pad 6 to highlight AILVATOR, then press the
ENTER key to display the AILVATOR menu. The cursor will default to
COMMON>COM.
3) Press the YES/+ or NO/- keys to choose the desired COM or SEP
option as described previously.
4) Press the Navigation Pad 6 to highlight ACT/INH>INH, then press
the YES/+ or NO/- keys to change the ACT/INH setting.
AILVATOR setting range is INH/ACT. The default setting is INH. When
Activated, the two elevator halves will function like elevators and ailerons.
Page 97