Gyro (Remote Gyro Gain Control) - AIRTRONICS SD-10G Operating Manual

heli Flight Mode menu
Changing the High Pitch Trim Authority Percentage Value
1) Press the Navigation Pad 6 to highlight H-PI-TRIM>100%, then press
the YES/+ or NO/- keys to change the High Pitch Trim Authority
percentage value.
Auxiliary Lever (VR5) will control High Pitch Trim only when the
throttle control stick is at 1% or higher control stick position.
H-PI-TRIM setting range is 0% to 100%. The default setting is 100%. Decreasing the H-PI-TRIM percentage value decreases
the overall High Pitch End Point travel when Auxiliary Lever (VR5) is used to control Point 9 of the Pitch Curve. When set to
100%, Auxiliary Lever (VR5) will move Point 9 of the Pitch Curve 25% in either direction from the center detent.
Changing the Low Pitch Trim Authority Percentage Value
1) Press the Navigation Pad 6 to highlight L-PI-TRIM>100%, then press
the YES/+ or NO/- keys to change the Low Pitch Trim Authority
percentage value.
Auxiliary Lever (VR6) will control Low Pitch Trim only when the
throttle control stick is at -1% or lower control stick position.
L-PI-TRIM setting range is 0% to 100%. The default setting is 100%. Decreasing the L-PI-TRIM percentage value decreases
the overall Low Pitch End Point travel when Auxiliary Lever (VR6) is used to control Point 1 of the Pitch Curve. When set to
100%, Auxiliary Lever (VR6) will move Point 1 of the Pitch Curve 25% in either direction from the center detent.

15.gYRO (REMOTE gYRO gain cOnTROL)

The Gyro function allows you to control Heading Hold mode gain and Rate mode gain remotely. Three separate Gyro function
settings can be programmed and each can be selected at any time using a three-position switch. For example, you might want
100% gain for aerobatic flight, but then switch to 75% gain for sport flying. In essence, when you assign a Gyro percentage
value to each of the three Gyro function settings, you effectively have triple-rates for your gyro, just like you have triple rates
for your elevator, aileron, and rudder control surfaces. Depending on the Gyro percentage value, you can adjust the gain in
either Heading Hold mode or Rate mode. In addition, you can program a Heading Hold gain percentage value and a Rate gain
percentage value separately, then switch between the two to aid in setting up your gyro. The Gyro function can be programmed
separately for each of the five Flight Modes.
Programming F-MODE
Current Switch Selection
Gyro Default Switch
Position Numbers: 16,17,18
Transmitter F-MODE refers to the Flight Mode that the transmitter is currently operating in. Programming F-MODE refers
to the Flight Mode that you would like to change the programming for.
IMPORTANT In order to use this feature, your gyro must support Remote Gain. For more information, and before using this
function, please refer to your gyro's Operating Guide to familiarize yourself with its setup and use.
The Current Switch Selection icon displays which Gyro function (gain percentage value) is currently Active for the current
Flight Mode.
Page 178
Transmitter F-MODE