General Information; Glid Flight Mode Menu Flow Chart - AIRTRONICS SD-10G Operating Manual

glid Flight Mode menu

gEnERaL inFORMaTiOn

To access the F-Mode menu, turn the transmitter ON. From the Top menu,
press the Navigation Pad 56 to highlight F-MODE, then press the ENTER
key to display the F-Mode menu.
From within any menu, press the END key continuously to return to the
Top menu.
Unless otherwise noted, all programming changes take effect immediately.
If the Top menu is not displayed when you turn the transmitter ON, continuously press the END key until the Top menu
is displayed.

gLiD FLigHT MODE MEnU FLOw cHaRT

01.SX MONITOR
6
02.STICK MONITOR
6
03.D/R
6
04.EXP
6
05.AI DIFFERENTIAL
6
06.LANDING
6
07.CAMBER
6
08.CAMBER POINT
6
09.CH DELAY
6
10.TRIM
6
11.TRIM STEP
6
12.TRIM AUTH
6
13.CROSS-TRIM
6
14.MIXING
6
15.C-MIX
6
16.VR ASSIGN
6
17.F-MODE COPY
6
18.F-MODE DELAY
6
19.F-MODE NAME
The five Flight Modes have been pre-named for your convenience, however, they have not been pre-programmed. The
Flight Modes have been named as follows: NORMAL (N), FLOAT (1), LAUNCH (2), REFLEX (3), and LAND (4).
See the IMPORTANT note on the next page regarding Flight Modes.
Use this Flow Chart to familiarize yourself with the GLID Flight Mode menu structure. Descriptions
regarding all GLID Flight Mode menu functions and programming are found on pages 115
through 155.
01.FLAP FREEZE POINT
6
02.CROW
6
03.LANDING DIFF
01.AI>RU1
6
02.AI>RU2
6
03.AI>RU3
6
04.AI>FL1
05.AI>FL2
6
06.FL>EL
6
07.RU>AI
6
08.GE>EL
Page 114
09.MT>EL
6
10.CB>EL
6
11.EL>CB