AIRTRONICS SD-10G Operating Manual page 94

aero Flight Mode menu
Choosing the Flight Mode - Common or Separate
When set to COM (Common), the SNAP ROLL settings will be the same regardless of which Flight Mode the transmitter is operating
in. You cannot program SNAP ROLL settings separately for each Flight Mode. When set to SEP (Separate), you can program
different SNAP ROLL settings separately for each Flight Mode.
1) Press the Navigation Pad 6 to highlight COMMON>COM, then press
the YES/+ or NO/- keys to choose either COM or SEP. If set to COM,
skip to the Choosing the Snap Roll Direction section. If set to SEP, see
step 2 below.
2) Press the F-MODE key to choose the F-MODE number you would like
to program the Snap Roll function for. Choose from N, 1, 2, 3, or 4. The
F-MODE (N) display will change, indicating which Flight Mode you are
programming the Snap Roll function for.
Choosing the Snap Roll Direction
1) Press the Navigation Pad 6 to highlight DIRECTION>AI-L/EL-D.
2) Press the YES/+ or NO/- keys to choose which direction you want the
ailerons and the elevator to move (i.e., which directions you want the
aircraft to perform the snap roll).
The following Snap Roll Direction options are available:
AI-L/EL-D - Ailerons Left, Elevator, Down, and Rudder Right.
AI-R/EL-D - Ailerons Right, Elevator Down, and Rudder Left.
Changing the Control Surface Percentage Values
Changing the control surface percentage values allows you to fine-tune the control throws so that the aircraft will perform the
snap roll in the desired manner intended.
WARNING Keep in mind that it's possible to set the control surface percentage values higher than the End Point Adjustments.
For example, with the aileron End Point Adjustment set to 100% and the Aileron Left percentage value set to 150% the servo
will move 150% when the Snap Roll function is Activated. We strongly recommend that you set your control surface percentage
values no higher than your End Point Adjustments unless specifically necessary for your particular setup. This will prevent any
chance of overdriving your control linkage.
1) Press the Navigation Pad 6 to highlight AI>L100% (AI>R100% if
AI-R/EL-D or AI-R/EL-U is selected).
2) Press the YES/+ or NO/- keys to change the Aileron control surface
percentage value.
AI setting range is R150% to L150%. The default setting is L100%
(R100% if AI-R/EL-D or AI-R/EL-U is selected).
3) Repeat the previous procedures to change the desired remaining control surface percentage values.
The channels displayed will vary based on Model Type and Model Type selection options currently selected. For example,
if your model features dual aileron servos and dual elevator servos, LA, RA, LE, and RE will be displayed and the control
surface percentage values can be changed for each servo individually.
If you decrease the percentage values to 0% and beyond, the percentage values will begin to increase in the opposite
direction. We don't suggest doing this unless you would like to use the percentage values to create your own custom control
throw configuration.
AI-L/EL-U - Ailerons Left, Elevator Up, and Rudder Left.
AI-R/EL-U - Ailerons Right, Elevator Up, and Rudder Right.
Page 94