Features Familiarization - AIRTRONICS SD-10G Operating Manual

features familiarization

TRanSMiTTER cOnTROL FEaTURES DiagRaMS
Use the diagrams below to familiarize yourself with the different control features of your new SD-10G transmitter. Descriptions of
these features can be found on pages 12 through 13.
The features referenced below are general in nature. Features specific to the Model Type (aircraft, helicopter, or sailplane)
can be found in those specific sections of this Operating Manual.
Left-Hand
Switch Array
Auxiliary Lever (VR6)
Left-Hand
Switch Array
Trim Switch (T6)
Throttle/Rudder
Control Stick (Mode 2)
Power Switch
Trim Switch (T4)
Trim Switch (T3)
Display Key
Direct Model Select Keys
LCD Display
Flight Mode Key
BACK
DIN
Connector
Charging
Jack
FRONT
Push-Button
Switch
Navigation Pad
Battery
Compartment
Memory Expansion Card Slot
(Inside Battery Compartment)
Page 11
Antenna
RF Output
Indicators
Push-Button Switch
Auxiliary Dial Knob (VR7)
Trim Switch (T2)
Charging Jack
Programming Keys
All switches (right- and left-hand switch arrays),
auxiliary levers, auxiliary push-buttons, and
the Auxiliary Dial Knob can be programmed to
perform different functions depending on the user's
preference. Some of these switches and buttons
are pre-programmed with specific functions based
on the Model Type. For default function assignments,
please see those specific sections of this Operating
Manual.
In the default configuration, the control sticks
are set to Mode 2 as shown above. The
transmitter can be set to Mode 1, Mode 3, or Mode 4.
For more information, see page 41.
Right-Hand
Switch Array
Trim Switch (T5)
Auxiliary Lever (VR5)
Aileron/Elevator
Control Stick (Mode 2)
Trim Switch (T1)