AIRTRONICS SD-10G Operating Manual page 96

aero Flight Mode menu
Choosing the Flight Mode - Common or Separate (All Mixing Options)
When set to COM (Common), the mixing settings will be the same regardless of which Flight Mode the transmitter is operating in.
You cannot program mixing settings separately for each Flight Mode. When set to SEP (Separate), you can program different
mixing settings separately for each Flight Mode.
1) Press the Navigation Pad 6 to highlight COMMON>COM, then press the YES/+ or NO/- keys to choose either COM or SEP.
If set to COM, skip to the Activating or the Percentage Value Selections sections. If set to SEP, see step 2 below.
2) Press the F-MODE key to choose the F-MODE number you would like
to program the mixing function for. Choose from N, 1, 2, 3, or 4. The
F-MODE (N) display will change, indicating which Flight Mode you are
programming the mixing function for.
Flaperon Mixing
The Flaperon Mixing function mixes flaps and ailerons, allowing you to use the ailerons as flaps if your model does not feature
separate flaps. When Activated, both ailerons are moved down at the same time to provide the function of flaps, while still providing
aileron roll control. Both ailerons can also be programmed to move up at the same time (spoilerons) to rapidly decrease lift. On
some aircraft, moving both ailerons up slightly can induce greater speeds and also aid in trimming.
Flaperons - Both ailerons down
To be able to Activate Flaperon mixing, your model must feature two separate aileron servos (one servo controlling each
aileron) and AILERON>2 must be selected SYSTEM 4 TYPE menu.
The Flaperons are controlled by the flap switch. Flap End Point Adjustments and Auxiliary Lever (VR6) programming
settings will carry over when the Flaperon mixing function is Activated. For example, to set the control throws for the
Flaperons, change the flap switch Switch Position N, 1, and 2 End Point Adjustment Values in the Surface menu. For more
information on Auxiliary Lever (VR6) programming, see page 91.
IMPORTANT To mix Elevator to Flaperons/Spoilerons for 3D aerobatic aircraft, a C-Mix must be used. For more information,
see page 104.
1) Press the Navigation Pad 56 to highlight MIXING, then press the ENTER key to display the MIXING menu. The FLAPERON
sub-menu will be highlighted by default.
2) Press the ENTER key to display the FLAPERON menu. The cursor will
default to COMMON>COM.
3) Press the YES/+ or NO/- keys to choose the desired COM or SEP
option as described previously.
4) Press the Navigation Pad 6 to highlight ACT/INH>INH, then press
the YES/+ or NO/- keys to change the ACT/INH setting.
FLAPERON setting range is INH/ACT. The default setting is INH. When
Activated, the flap switch will control the Flaperons.
Spoilerons - Both ailerons up.
Page 96