AIRTRONICS SD-10G Operating Manual page 60

SYSTEM MENU
Installing the Memory Expansion Card
1) Open the battery cover by first pushing the two latches inward, then by pulling up on the bottom of the battery cover.
2) Carefully remove the plug that covers the Memory Expansion Card slot (adjacent to the battery connector) by firmly pulling it
up and out.
3) Make sure that the SD-10G transmitter is turned OFF, then carefully install the Memory Expansion Card, making sure that the tab
on the bottom of the Memory Expansion Card lines up with the groove in the Memory Expansion Card slot and that the mounting
pins line up with the pin receptacle. Gently push the Memory Expansion Card down into place and verify that it's fully seated.
If the Memory Expansion Card is brand new or if you want to reset the programming data of the models stored on the
Memory Expansion Card, see the Initializing the Memory Expansion Card section below.
Listing Contents of the Memory Expansion Card
1) Turn the SD-10G transmitter ON. Highlight the System menu, then
press the ENTER key.
2) Press the Navigation Pad 56 to highlight MEMORY PACK, then press
the ENTER key to display the MEMORY PACK menu. The LIST
sub-menu will be highlighted by default.
3) Press the ENTER key to display the models currently stored on the
Memory Expansion Card. The Model Number, Model Name, and Model
Type (AERO, GLID, or HELI) will be displayed for each model.
If the Memory Expansion Card is not installed, or if it is not Initialized, PACK NOT READY? will be displayed. If this occurs,
press any key to return to the Memory Pack menu.
The Memory Expansion Card stores up to 20 models. Models stored on the Memory Expansion Card are denoted with
an 'M'. Models stored on the Memory Expansion Card are numbered M21~M40.
Initializing the Memory Expansion Card
After the Memory Expansion Card is installed, but before it can be used, it must be Initialized.
1) Turn the SD-10G transmitter ON, press the Navigation Pad 56 to highlight the System menu, then press the ENTER key.
2) Press the Navigation Pad 56 to highlight MEMORY PACK, then press
the ENTER key to display the MEMORY PACK menu. The LIST
sub-menu will be highlighted by default.
3) Press the Navigation Pad 6 to highlight INITIAL, then press the
ENTER key to display the INITIAL menu. The cursor will default to
INITIAL>HELI and PUSH ENTER KEY!! will be displayed.
4) Press the YES/+ or NO/- keys to choose which default Model Type you would like to Initialize the Memory Expansion Card
with. Choose from AERO, GLID, or HELI.
When Initialized, all 20 models will be of the same Model Type you chose to Initialize the Memory Expansion Card with.
Model Types can be changed after Initialization through the Model Select and Model Type menus.
Page 60