Mixing (Revolution Mixing And Channel Mixing) - AIRTRONICS SD-10G Operating Manual

heli Flight Mode menu
1) Press the Navigation Pad 56 to highlight GOVERNOR1>100%, then
press the YES/+ or NO/- keys to change the Governor 1 percentage
value.
When the Governor 1 percentage value is set to 0%, the governor
will be in 'pass-through' mode (e.g., OFF). This value can vary by
manufacturer. Make sure to check your governor's Operating Guide for
more information. For example, some governors may be OFF when the
percentage value is set anywhere between -5% and 5%.
2) Press the Navigation Pad 6 to move the cursor to GOVERNOR2>100%,
then press the YES/+ or NO/- keys to change the Governor 2
percentage value.
3) Press the Navigation Pad 6 to move the cursor to GOVERNOR3>100%,
then press the YES/+ or NO/- keys to change the Governor 3
percentage value.
GOVERNOR1, GOVERNOR2, and GOVERNOR3 setting range is -150% to 150%. The default setting for each is 100%.
Decreasing the GOVERNOR percentage values decreases rotor head speed and increasing the GOVERNOR percentage
values increases rotor head speed. See the IMPORTANT note on the bottom of the previous page regarding the use of positive
and negative Governor percentage values and how they affect the use of your governor.
If you prefer to use the same Governor function settings across all Flight Modes, instead of programming separate Governor
function settings for each Flight Mode, you can control up to two separate Governor function settings via a three-position
switch. To do this, plug your governor into the AUX3 channel and adjust the AUX3 channel High and Low End Point Adjustments
in the Surface menu to set the desired Governor percentage values. In the default configuration, Switch Position 28 is AUX3L and
Switch Position 30 is AUX3H. For example, with the switch in Switch Position 28, you might have 100% End Point Adjustment for
maximum rotor head speed and with the switch in Switch Position 30, you might have 75% End Point Adjustment for decreased rotor
head speed. When the switch is in Switch Position 29 (centered), the governor will be will be in 'pass-through' mode (e.g., OFF).

17.Mixing (REvOLUTiOn Mixing anD cHannEL Mixing)

The SD-10G transmitter features the most common pre-programmed mixes that can all be adjusted to suit just about any model
setup or mixing need that you might have. If for some reason one of the pre-programmed mixes will not suffice, you can
custom-program one or more of the available five Compensation Mixers. For more information, see page 187.
1) Press the Navigation Pad 56 to highlight MIXING, then press the
ENTER key to display the MIXING menu. The REVO-MIX sub-menu
will be highlighted by default.
The pre-programmed mixes shown in the tables below are available.
MIX
REVO-MIX
EL 4 TH
Aside from Revolution Mixing, all pre-programmed mixes are described in the following manner: Master 4 Slave. For
example, For the EL 4 TH mix, the Elevator channel is the Master and the Throttle channel is the Slave. In all cases, the
Master channel always controls the Slave channel.
DESCRIPTION
Revolution Mixing
Elevator to Throttle Mixing
MIX
AI 4 TH
RU 4 TH
Page 181
DESCRIPTION
Aileron to Throttle Mixing
Rudder to Throttle Mixing