Mixing (Channel Mixing) - AIRTRONICS SD-10G Operating Manual

glid Flight Mode menu
3) Press the F-MODE key to choose the F-MODE number you would like to program the Cross-Trim function for. Choose
from N, 1, 2, 3, or 4. The NORMAL (N) display will change, indicating which Flight Mode you are programming the Cross-Trim
function for.
Changing the Flap/Elevator Cross-Trim
1) Press the Navigation Pad 6 to highlight FL 34 EL>INH, then press the
YES/+ or NO/- keys to change the FL 34 EL Cross-Trim setting.
CROSS-TRIM setting range is INH/ACT. The default setting is INH.
When Activated, the flap trim switch will control the elevator trim and the
elevator trim switch will control the flap trim.
Changing the Aileron/Rudder Cross-Trim
1) Press the Navigation Pad 6 to highlight AI 34 RU>INH, then press the YES/+ or NO/- keys to change the AI 34 RU
Cross-Trim setting.
CROSS-TRIM setting range is INH/ACT. The default setting is INH. When Activated, the aileron trim switch will control the
rudder trim and the rudder trim switch will control the aileron trim.
The Camber Preset function on Trim Switch (T5) is not affected by the FL 34 EL Cross-Trim settings.

14.Mixing (cHannEL Mixing)

The SD-10G transmitter features a number of pre-programmed mixes that
can all be adjusted to suit just about any model setup or mixing need that
you might have. If for some reason one of the pre-programmed mixes will
not suffice, you can custom-program one or more of the available five
Compensation Mixers. For more information, see page 147.
1) Press the Navigation Pad 56 to highlight MIXING, then press the
ENTER key to display the MIXING menu. The AI 4 RU1 sub-menu will
be highlighted by default.
The pre-programmed mixes shown in the tables below are available.
MIX
Aileron to Rudder Mixing (1~3)
AI 4 RU1~RU3
AI 4 FL1~2
FL 4 EL
RU 4 AI
All pre-programmed mixes are described in the following manner: Master 4 Slave. For example, For the AI 4 RU1 mix, the
Aileron channel is the Master and the Rudder channel is the Slave. In all cases, the Master channel always controls the
Slave channel.
All pre-programmed mixes are Linear unless otherwise noted. For example, if you Activate the AI 4 RU1 mix and set the
mixing percentage value to 50%, the aileron servos will travel half the amount that the rudder servo moves at any given
control stick position.
WARNING When a pre-programmed mix is Activated, you still have separate control over the Slaved channel, however,
depending on the mixing percentage value, the Slave channel End Point Adjustment could be exceeded. We strongly
recommend that if you use the pre-programmed mixes that you set your Slave channel Limits no higher than that channel's
End Point Adjustment unless specifically necessary for your particular setup. This will prevent any chance of overdriving your
control linkage when the mix is used.
DESCRIPTION
Aileron to Flap Mixing (1~2)
Flap to Elevator Mixing
Rudder to Aileron Mixing
MIX
GE 4 EL
MT 4 EL
CB 4 EL
EL 4 CB
Page 138
DESCRIPTION
Gear to Elevator Mixing
Motor to Elevator Mixing
Camber to Elevator Mixing
Elevator to Camber Mixing